The most important thing was to stop all the cold air from coming in. Stopping all the drafts must be done before insulation is added. I temporarily decommissioned my garage door and covered it with a large plastic sheet and 2x4s that I had laying around, being careful to seal it as best as possible around the edges and bottom. I patched up some holes in the drywall and taped the cracks around the attic hatches. By leaving the door to the house open, the garage becomes part of the heated space of the house. I didn't need to install a duct feeding the garage, because the furnace naturally sucks warm air from the house into the garage when its running. It's not the most efficient or safe setup ... but it's definitely the most cost effective solution for one or two winter seasons. It's not efficient because the garage space isn't completely insulated and also the furnace is now sucking warm air out of the house and releasing it out the roof vent. Nonetheless, I now have a heated garage and only marginally more expensive heating bills.
The garage is at a cozy 62F when its in the 40's outside and 68F inside the house. It could be warmer if I added insulation but that costs money. The coldest surface inside the garage is probably the concrete floor ... and I'm never going to try to insulate that.
One problem is that my garage isn't long enough to plane long pieces of lumber with the garage door closed ... so I stick the ends of the lumber through the open living room door to feed them into the planer! (I have a very understanding wife ... as long as I have a curtain up to keep the sawdust out of the house).
The garage door probably won't be opened until the flipping.
No comments:
Post a Comment